SY->Module-2 : LATHE ACCESSORIES - Practice Mode

1) Which accessory is used in between centre work?
Correct Answer: Catch plate
2) Which one of the below is a work holding device?
Correct Answer: Four jaw chuck
3) Which work holding method is to be used if, high degree of concentricity is needed?
Correct Answer: In between centres
4) Which method of holding is used for lengthy work to avoid over hanging?
Correct Answer: In between centres
5) Which work holding device is used to hold irregular shaped work?
Correct Answer: Face Plate
Previous Question Set Back to Question Sets Next Question Set
Try Another Topic
Try Another Quiz