SY->Module-2 : LATHE ACCESSORIES - Practice Mode

1) What is the cut of file used for deburring the job on lathe?

Rasp cut file Double cut file Curved cut file Single cut file

Correct Answer: Single cut file

2) Which file is used for filing surfaces at right angle on already finished surface?

Flat file Needle file Safe edge file Curved cut file

Correct Answer: Safe edge file

3) Which grade of file is used for heavy reduction of material?

Smooth file Bastard file Second cut file Dead smooth file

Correct Answer: Bastard file

4) Which is used to mark the center of a round rod?

Divider Jenny caliper Inside caliper Outside caliper

Correct Answer: Jenny caliper

5) Which punch is used for locating center of the hole?

Dot punch Prick punch Center punch Hollow Punch

Correct Answer: Center punch

Previous Question Set Back to Question Sets Next Question Set

Try Another Topic

Try Another Quiz